- Pump filter for AXYZ CNC Router only. 

- For added safety, we have produced a SmartConsole with an E-Stop button mounted on the device, this allows the operator to stop the machine in case of an emergency. 

- For AXYZ CNC Router only

For added safety, we have produced a SmartConsole with an E-Stop button mounted on the device, this allows the operator to stop the machine in case of an emergency.

- For AXYZ CNC Router only

- The 32oz (1L) Unist Mister Reservoir is ideal for machines that are required to run for a long time or use a high volume of coolant.
- For AXYZ CNC Router only

- For AXYZ CNC Router only

- This is a replacement blast gate for high capacity pressure feet.
- The Blast Gate allows you to adjust the amount of air going into the pressure foot depending on the application. It is used to replace damaged blast gates.

- The bellows system provides an extremely efficient vacuum performance. The bellows completely enclose the tooling, virtually elimination all vacuum leakage.

- The A2MC Power Board supplies and distributes power to the machine’s motor drives. It is a UL certified device that can power up to 8 motor drives. The nominal operating voltage is 65 VDC.

Please note: Fuses are not included.

- RS485 Modbus module for AXYZ CNC Router

- The 12VDC Solenoid - 5 Port valves are generally used for tool changers.

- Pulleys are a vital part to support the cnc router machine. There primary use is to support the movement of the Z plate.

- This sensor is fitted with a 3 pin Molex connector on approximately 2 m (6 ft) of cable.

- Replacement Lexan door for a 7G ATC

- The USB to RS485 converter box is used to communicate between a PC running Toolpath and an AMC machine controller.  This device plugs into a USB port on the PC and converts the communication signal to RS485 which can be then connected to the AMC controller. 

- The bridge rectifier supplies the power to an AMC machine’s stepper drives.
- This version plugs into the connection board. If this part has failed there is no power to the stepper drives.
- A more powerful bridge rectifier is available if you have a multi head machine or you are having problems with this part failing frequently.

- The newly constructed Phenolic Pressure Foot Donut is now blind (top-down) mounted.
- Our new blind mount donut replaces the old bottom-up design and fits all AXYZ High Capacity Pressure Feet.

- Spindle plates are designed to mount the various sizes and types of spindles to the Z axis of the CNC machine.
- These plates ensure the spindle is mounted vertically and spaced correctly for all the machine options.
- The spindles can be adjusted vertically.