- The Holding Break is used to hold either a stepper or servo Z axis in place when the power is turned off.

- Inverters (also called Variable Frequency Drives or VFD) are generally used to power high speed spindles. However they are sometimes used to power other motors, especially pumps and blowers in single phase applications.

- Saber Blade for CNC Router 

-The Brush Donut can be fitted on the bottom of the high capacity pressure foot. The brush helps prevent scratching when machining very sensitive materials.

- The Vexta PK299F4.5 Stepper motor includes a 24 tooth pulley and terminated cables. Double stack motor with a holding torque exceeding 600 once-inches (4.3 N-m).

This motor is the most commonly used stepper motor for X and Y axis in all AXYZ stepper system router tables.

- Pneumatic Male Run Tee 1/8'' PT x 4 mm x 4 mm for AXYZ CNC Router

- The A2MC Power Board supplies and distributes power to the machine’s motor drives. It is a UL certified device that can power up to 8 motor drives. The nominal operating voltage is 65 VDC.

Please note: Fuses are not included.

- Replacement 5-pin stepper drive plug for AXYZ CNC routers.

- RS485 Modbus module for AXYZ CNC Router

- Replacement 3-pin stepper drive plug for AXYZ CNC routers.

- The 12VDC Solenoid - 5 Port valves are generally used for tool changers.

- Pulleys are a vital part to support the cnc router machine. There primary use is to support the movement of the Z plate.

- Origin: US

- This sensor is fitted with a 3 pin Molex connector on approximately 2 m (6 ft) of cable.

- This sensor is fitted with a 3 pin Panduit header on approximately 2 m (6 ft) of cable.

- This sensor directly connects to sensor cabling.

- This sensor is fitted with a 3 pin Molex connector on approximately 100 mm (4 inches) of cable.

- The 3 Way Pneumatic Valve is generally used to control the machine’s pressure foot. There will be one valve for each pressure foot installed on the machine.

- For AXYZ CNC Router

- This adapter can be fitted to a standard grease gun (not supplied) and is used to apply grease to THK Linear Bearings.

- This adapter can be fitted to a standard grease gun (not supplied) and is used to apply grease to Star Linear Bearings.

- Replacement Lexan door for a 7G ATC

- For AXYZ CNC router only